Electrolux EHH9967FOZ Notice D'utilisation page 16

16 www.electrolux.com
Problem
Automatic Heat Up func‐
tion does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when
you touch the panel sensor
fields.
comes on.
comes on.
comes on.
and a number come on. There is an error in the
comes on.
Possible cause
The zone is hot.
The highest heat setting is
set.
Power management func‐
tion operates.
The cookware is too large
or you put it too near to the
controls.
The signals are deactiva‐
ted.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too
small for the zone.
hob.
The electrical connection is
incorrect. The supply volt‐
age is out of range.
Remedy
Let the zone become suffi‐
ciently cool.
The highest heat setting
has the same power as the
function.
Refer to "Daily use" chap‐
ter.
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chap‐
ter.
Deactivate the hob and ac‐
tivate it again.
Refer to "Daily use" chap‐
ter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Hints and tips"
chapter.
Use cookware with correct
dimensions.
Refer to "Technical infor‐
mation" chapter.
Disconnect the hob from
the electrical supply for
some time. Disconnect the
fuse from the electrical
system of the house. Con‐
nect it again. If comes
on again, speak to an Au‐
thorised Service Centre.
Speak to a qualified electri‐
cian to check the installa‐
tion.