Electrolux EHL9530FOK Notice D'utilisation page 11

Masquer les pouces Voir aussi pour EHL9530FOK:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after
you activate the hob,
• you spill something or put something
on the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking
zone cool down before you use the
hob again.
• you use incorrect cookware. The
symbol
comes on and the cooking
zone deactivates automatically after 2
minutes.
• you do not deactivate a cooking zone
or change the heat setting. After some
time
comes on and the hob
deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 3
4 - 7
8 - 9
10 - 14
5.3 The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
The hob deacti‐
vates after
6 hours
5 hours
4 hours
1.5 hour
5.4 Using the cooking zones
Put the cookware on the cross / square
which is on the surface that you cook.
Cover the cross / square fully. Induction
cooking zones adapt to the dimension of
the bottom of the cookware
automatically. You can cook with the
large cookware on two cooking zones at
the same time.
5.5 Automatic Heat Up
Activate this function to get a desired
heat setting in a shorter time. When it is
on, the zone operates on the highest
setting in the beginning and then
continues to cook at the desired heating
setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch
(
Immediately touch a desired heat setting.
After 3 seconds
To deactivate the function: change the
heat setting.
5.6 Power function
This function makes more power
available to the induction cooking zones.
The function can be activated for the
induction cooking zone only for a limited
period of time. After this time the
induction cooking zone automatically
sets back to the highest heat setting.
Refer to "Technical data"
chapter.
To activate the function for a cooking
zone: touch
.
To deactivate the function: change the
heat setting.
5.7 Timer
Count Down Timer
You can use this function to set how long
the cooking zone should operate for a
single cooking session.
ENGLISH
comes on).
comes on.
comes on.
11

Publicité

Table des Matières
loading

Table des Matières