Directions For Use; Assembling The Gas Heater - Qlima GH 959 RF Manuel D'utilisation

• Do not use in bathrooms, bedrooms, base-
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not
• Gas tube length < 1 meter, ø 8-10 mm.

ASSEMBLING THE GAS HEATER

•
•
•
•
•
•
•
•
4
72
with reduced physical, sensory or men-
tal capabilities or lack of experience and
knowledge if they have been given super-
vision or instruction concerning use of the
appliance in a safe way and understand
the hazards involved.
ments or high rise buildings.
be made by children without supervision.
Carefully remove your heater from the box and check the contents. In addi-
tion to the heater you should also have:
Directions for Use for the gas heater
Remove all other packaging materials and check the heater for any damage.
If you have any doubts concerning the heater, please contact qualified service
personnel. Keep all packaging material out of the reach of young children.
Unscrew the fixing screws at the rear of the gas heater. Disconnect the rear
cover from the heater.
Before connecting the low-pressure regulator, please check and read the
following: The gas heater should only be powered by Propane-Butane in a
container with a maximum weight of 15kg. Connect the low-pressure regu-
lator with a fixed calibration of maximum 30 mbar that complies with EN
12864:2002. The hose should be according to national standards. For correct
connection, the hose should be connected using metal bands of a suitable
size. For correct connection, follow the instructions provided with the low-
pressure regulator.
Slide the two metal rings around the hose. Connect the hose to the hose
union of the low-pressure regulator and to that of the tab. Close the metal
rings firmly with a screw, but make sure that you do not damage the fitting
or any component.
Before connecting the low-pressure regulator to the gas container, make sure
that the gas container is closed and that there are no open flames (i.e. a lit
oven) in the place where you are working. Connect the low-pressure regula-
tor according to the user instructions that are provided with the low-pressure
regulator.
Check for gas leaks: see section F
Place the gas container in its compartment. Take care that the hose is not
twisted or obstructed, and that it is unable to touch any hot parts of the hea-
ter.
Hook the rear cylinder cover onto the compartment by inserting the two
hooks into the respective holes of the cabinet. Screw the two screws again
into the rear of the heater.