Sevylor Bali K67-7 Notice D'utilisation page 5

MAINTENANCE : DEFLATING – FOLDING THE BOAT – CLEANING – WINTERING STORAGE
1. Remove paddles and other accessories.
2. To deflate, unscrew the valves' insert and open the valve cap of the push-in valve.
3. Clean and check the item as well as all the accessories after each use. Rinse it thoroughly making sure that any salt
residues are removed, if it has been used in salt water. Use a mild soapy solution, but do not use detergents or any
type of silicone-based products. Make sure that the product is completely dry before putting it away.
4. Fold the 2 sides into the middle, then roll it up from the opposite end of the valves (so remaining air can escape from
the valves); start again if you feel there is still some air in the tubes.
5. When storing your inflatable, keep it in a clean and dry place, away from extreme temperature variations or other
potentially damaging factors. It can be stored deflated and rolled up in a bag or assembled and lightly inflated. Store it
away from rodents.
HOW TO REPAIR SMALL PUNCTURES
You can repair small punctures with the repair kit supplied. (NOTE: Glue not included in USA.) Please note that in order
for the repair to be successful, the humidity level should be less than 60%, and the temperature between 18° C and 25° C.
Avoid carrying out repairs in the rain or in direct sunlight.
Check that the tube is fully deflated and lies flat.
1. Cut a round patch at least 2" / 5 cm larger than the damaged area.
2. Clean the damaged area and the corresponding side of the patch with an alcohol-based grease remover and allow it
to dry for 5 minutes.
3. Apply 3 thin layers of glue to both the patch and the damaged area; allow it to dry for 5 minutes between layers until
the glue feels tacky.
4. When the third layer of glue is dry, apply the patch without pressing down, and adjust the position if required. Remove
any air bubbles which may have formed under the patch by smoothing the patch with a round object such as a spoon.
Start in the centre of the patch and work towards the outside. Clean off the excess glue with a solvent. Drying : 12
hours.
Perform repairs in a well-ventilated area.
Avoid inhaling glue vapours or swallowing the glue.
N.B. The seams must not be glued. Only the manufacturer of the boat can perform repairs on the seams.
WARRANTY
Sevylor warrants (legal warranty) to the original purchaser only, and from date of purchase, when any product is used for
normal recreational purposes, that the product is free from defects (weldings). Check with your local Sevylor office for
warranty duration details, which vary for different countries. The warranty does not cover any puncture, cut or abrasion
sustained in normal use or damage from unreasonable uses or improper storage.
If any product is found to be defective, the owner may return it to the store it was purchased from with the
original sales receipt. After inspection of any product found defective, Sevylor shall either repair or replace the defective
part or item as deemed necessary by Sevylor.
Sevylor shall not be held liable for incidental and consequential damages.
There are no warranties which extend beyond the description of the face hereof.
This warranty is inclusive in lieu of all other warranties.
This warranty gives you specific legal rights and you may also have other rights, which may vary, from country to country.
The main limitations to the application of the warranty are the following :
The item must not be modified and/or fitted with a motor in excess of that allowable by the manufacturer or
•
used in any activities outside normal recreational use (such as races, rental, professional usage).
Use in excess of the manufacturers recommended maximum load capacity.
•
Pressure recommendations, assembly / disassembly and handling procedures must be strictly observed.
•
The maintenance and the storage procedures must not be neglected.
•
This warranty does not cover parts and accessories not supplied or recommended by the manufacturer or
•
defects resulting from the installation of such equipment on their products.
NOTICE : all repairs covered by warranty must be performed by Sevylor.
Your product is designed in accordance with the standards for a specific use. Any modifications,
transformations or use of a motor horse power higher than indicated by the manufacturer could result in serious
risks for the user and will void the warranty.
WARNING !
Avoid contact with the skin or the eyes.
Keep all repair materials (glue, solvents, etc.)
out of the reach of children.
WARNING !
5
E
N
G
outo
L
I
S
H