Eazyzap FP983 Mode D'emploi page 3

• Danger - High voltage!
• The appliance emits UV
radiation. Do not stare at the
light.
• The appliance is not to be
used in locations where
flammable vapour or
explosive dust is likely to
exist.
• Do not use in barns, stables
and similar locations.
• EAZYZAP recommend that
this product is connected
to a circuit protected by an
appropriate RCD (Residual
Current Device).
Product Description
FP983 - LED Pest Killer - Small
FP984 - LED Pest Killer - Medium
FP985 - LED Pest Killer - Large
Introduction
Please take a few moments to carefully read
through this manual. Correct maintenance and
operation of this machine will provide the best
possible performance from your EAZYZAP product.
Pack Contents
The following is included:
• Pest Killer
• Instruction manual
• Hanging chain
EAZYZAP prides itself on quality and service,
ensuring that at the time of packaging the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your EAZYZAP dealer immediately.
FP983-FP984-FP985_ML_A5_v3_20210611.indb 3 FP983-FP984-FP985_ML_A5_v3_20210611.indb 3
Installation
Note: Ensure the mounting substrate and
the fixings used can support the weight of
the appliance. If in doubt seek professional
advice or assistance.
1. Remove all packaging and protective film from
the Pest killer.
2. For best results, locate the Pest killer in the
darkest part of the room, but at least 1 metre
away from food preparation areas.
Note: Close proximity to other light sources
such as sky lights and windows will reduce
the effectiveness of the Pest killer.
3. Connect the appliance to mains power.
Operation
WARNING: Under no
circumstances should hands be
placed anywhere near the high
voltage grid when the appliance
is operational.
The pest killer works by luring pests on to an
electrified metal grid using ultra-violet light. It uses
no chemicals and is pollution free. To use the Pest
killer:
1. Press the switch to the ON (I) position. Ensure
it is set to OFF (O) before plugging into mains.
2. The light will come on and the grid will become
electrically charged.
UK
3
2021/6/11 13:58 2021/6/11 13:58