Makita DCS460 Manuel D'emploi Et De Sécurité page 29

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Chain typ
D
α
E
1
F
486
496
4/5
2
Files and how to work with them
Use a special saw chain round file for sharpening. Standard
round files are unsuitable. For the order number, see "Acces-
sories".
Type 486: Use 11/64" (4,5 mm) dia. round saw-chain file.
Type 496: Use 7/32" (5,5 mm) dia. round saw-chain file.
The file should cut only when pushed forwards (arrow). Lift the
file when leading it backwards.
First sharpen the shortest cutter. The length of this cutter is
then the standerd for all other cutters of the chain.
New saw teeth must be filed to the exact same shape as the
used teeth, including on their running surfaces.
File depending on chain type (10° to the guide bar).
A file holder makes file guidance easier. It is marked for the
correct sharpening angle of:
α = 25°
(keep the marks parallel with the chain when filing, see
illustration) and limits the cut depth to the correct 4/5 of the file
diameter. See "Accessories" for the order number.
After having sharpened the chain, the height of the depth limiter
must be checked by means of a chain gauge. See "Accesso-
ries" for the order number.
Correct even the smallest excess height with a special flat
file (1). See "Accessories" for the order number.
Round off the front of the depth limiter (2).
29

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Dcs510

Table des Matières