Makita DCS460 Manuel D'emploi Et De Sécurité page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3
WARNING!
There is an extreme danger of kickback at this
point. Extra caution must be taken to maintain
control of the saw. To make the felling cut, follow
the sectioning method described previously (fig.
29). If you are inexperienced with a chain saw
plunge-cutting should not be attempted. Seek the
help of a professional.
Limbing
Limbing is removing the branches from a fallen tree.
WARNING!
There is an extreme danger of kickback during the
limbing operation. Do not work with the nose of the
bar. Be extremely cautious and avoid contacting
the log or other limbs with the nose of the guide bar.
Do not stand on a log while limbing it - you may slip
or the log may roll.
Start limbing by leaving the lower limbs to support
the log off the ground (fig. 30). Always cut from the
top of the limb. Do not underbuck freely hanging
limbs. A pinch may result or the limb may fall,
causing loss of control. If a pinch occurs, stop the
engine and remove the saw, by lifting the limb.
WARNING!
Be extremely cautious when cutting limbs under
tension. The limbs could spring back toward the
operator and cause loss of control of the saw or
injury to the operator.
Bucking
Bucking is cutting a log into sections.
2
29
1
1. When bucking, do not stand on the log. Make
2. Cut only one log at a time.
3. Shattered wood should be cut very carefully.
30
4. When cutting small logs, use a sawhorse (fig.
WARNING!
sure the log will not roll down-hill. If on a slope,
stand on the up-hill side of the log (see fig. 31).
Watch out for rolling logs.
WARNING!
WARNING!
Sharp slivers of wood may be caught and flung
in the direction of the operator of the saw.
WARNING!
32). Never permit another person to hold the
log. Never hold the log with your leg or foot.
31
32
15

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Dcs510

Table des Matières