Publicité
Les langues disponibles
Les langues disponibles
Problem
Washing takes longer time than
specified in the manual.(*)
Programme time does not
countdown. (On models with
display) (*)
Programme time does not
countdown. (*)
Machine does not switch to
spinning step. (*)
Washing performance is poor:
Laundry turns gray. (**)
Washing performance is poor:
Stains persist or the laundry is
not whitened. (**)
24 / EN
Reason
Water pressure is low.
Voltage might be low.
Input temperature of water might be low.
Number of rinses and/or amount of rinse water
might have increased.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent usage.
Timer may stop during water intake.
Timer may stop during heating step.
Timer may stop during spinning step.
There might be unbalanced load in the machine.
There might be unbalanced load in the machine.
The machine will not spin if water is not drained
completely.
Excessive foam might have occurred and
automatic foam absorption system might have
been activated due to too much detergent usage.
Insufficient amount of detergent has been used
over a long period of time.
Washing was made at low temperatures for a
long time.
Insufficient amount of detergent is used with
hard water.
Too much detergent is used.
Insufficient amount of detergent is used.
Excessive laundry was loaded in.
Wrong programme and temperature were
selected.
Wrong type of detergent is used.
Too much detergent is used.
Solution
• Machine waits until taking in adequate
amount of water to prevent poor washing
quality due to the decreased amount of
water. Therefore, the washing time extends.
• Washing time is prolonged to avoid poor
washing results when the supply voltage
is low.
• Required time to heat up the water extends
in cold seasons. Also, washing time can be
lengthened to avoid poor washing results.
• Machine increases the amount of rinse water
when good rinsing is needed and adds an
extra rinsing step if necessary.
• Use recommended amount of detergent.
• Timer indicator will not countdown until the
machine takes in adequate amount of water.
The machine will wait until there is sufficient
amount of water to avoid poor washing
results due to lack of water. Timer indicator
will resume countdown after this.
• Timer indicator will not countdown until the
machine reaches the selected temperature.
• Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
• Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
• Automatic unbalanced load detection system
might be activated due to the unbalanced
distribution of the laundry in the drum.
• Check the filter and the draining hose.
• Use recommended amount of detergent.
• Use the recommended amount of detergent
appropriate for water hardness and the
laundry.
• Select the proper temperature for the
laundry to be washed.
• Using insufficient amount of detergent with
hard water causes the soil to stick on the
cloth and this turns the cloth into gray in
time. It is difficult to eliminate graying once
it happens. Use the recommended amount
of detergent appropriate for water hardness
and the laundry.
• Use the recommended amount of detergent
appropriate for water hardness and the
laundry.
• Use the recommended amount of detergent
appropriate for water hardness and the
laundry.
• Do not load the machine in excess. Load with
amounts recommended in the "Programme
and consumption table".
• Select the proper programme and
temperature for the laundry to be washed.
• Use original detergent appropriate for the
machine.
• Put the detergent in the correct
compartment. Do not mix the bleaching
agent and the detergent with each other.
Washing Machine / User's Manual
Publicité
