Abus FU8320W/B Instructions D'installation page 13

4. Signal LEDs
Operating state
Operating mode
Transmit / IR programming mode
Programming mode for internal
detectors
5. Activating the LED
Attach a jumper to contacts LK1 and LK3. Short-
circuit the LK4 contact with a jumper until the LED
flashes continuously. Remove this again. The LED
is now activated. Restore the original position of
the jumper.
6. Deactivating the LED
Attach a jumper to contact LK1. Short-circuit the
LK4 contact with a jumper until the LED flashes
continuously. Remove this again. The LED is now
deactivated. Restore the original position of the
jumper.
Signal
No signal
4 x flash
Continuous
flashing
Signal LED
GB