Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
28 www.aeg.com
Problem
The temperature in
the refrigerator is
too high.
The temperature in
the freezer is too
high.
There is too much
frost.
8.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
2
8.2 Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
9. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
There is no cold air circu-
lation in the appliance.
Products are too near to
each other.
Food is not wrapped cor-
rectly.
The door is not closed
correctly.
The temperature regula-
tor is not set correctly.
1
1
Solution
Make sure that there is
cold air circulation in the
appliance.
Store products so that
there is cold air circulation.
Wrap the food correctly.
Refer to "Closing the
door".
Set a higher temperature.
1.
At the same time, with the fingers ex-
pand up and down the transparent
cover and unhook it in the direction of
the arrows.
2.
Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maxi-
mum power is shown on the light bulb
cover).
3.
Reassemble the lamp cover.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the
light comes on.
3.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
9.1 Positioning
This appliance should be installed in a
dry, well ventilated indoor where the am-
bient temperature corresponds to the
climate class indicated on the rating
plate of the appliance:
Publicité
Chapitres
Table des Matières
