AGA marvel ML24RD Instructions D'installation, D'utilisation Et D'entretien page 15

Step 4: Reinstall the Drawers
1. Fully extend drawer slides and place drawer on slides.
Be sure that drawer sits evenly on both slides and clips
slide into place in rear of drawer.
2. Re-install wire harness at rear corner of top drawer.
3. Re-install two screws through drawer into slides.
OVERLAY DRAWER PANEL INSTALLATION
Figure 18
15
Screw clearance
hole through
gasket extrusion
Figure 18a
Overlay panel
flush with top
edge of drawer
Custom overlay
panel to be cen-
tered on width of
drawer.
Using clearance holes in
gasket channel mark
hole locations onto panel