Cameo PAR 64 CAN Manuel D'utilisation page 14

COLOUR JUMPING MODE
Press the mode button to select the Colour Jumping Mode. Press Enter (2. digit blinks) to select 15 Colour and Strobe by using UP and DOWN
buttons. Press ENTER (3. and 4. digit blink) again to adjust jumping/strobe speed (00-99) by using UP and DOWN buttons.
15 Colour
00 - 99 speed adjustable.
COLOUR FADING MODE
Press the mode button to select Colour Fading Mode. Press Enter (2. digit blinks) to select 15 Colour and Strobe by using UP and DOWN buttons. Press ENTER
(3. and 4. digit blink) again to adjust fading/strobe speed (00-99) by using UP and DOWN buttons.
15 Colour
00 - 99 speed adjustable.
AUTO RUNNING MODE
Press the mode button to select Auto mode. The unit will then run automatically through all of the built-in programmes. The run speed can be pre-
set via the speed of the colour change and colour fade modes.
SLAVE MODE
Press the MODE button to enter SLAVE MODE.
Link the slave unit and the master unit via DMX cable. The slave unit will follow in sequence with the master unit
LED ON/OFF MODE
Press the MODE button to enter the LED ON/OFF mode (repeatedly if necessary). Then press enter to set LED display to ON or OFF by using the UP
and DOWN buttons. In ON mode the LED display will be on permanently. In OFF mode the LED display will be switched off automatically after 5
seconds. It will be turned on again by pressing any of the four buttons.
SOUND CONTROL MODE
Press the mode button to select Sound Control Mode. The unit will then run thanks to the built in microphone. Press ENTER (3. and 4. digit blink)
again to adjust microphone sensitivity (00-99) by using UP and DOWN buttons.
DMX ADDRESS SETTING MODE
Press the MODE button to enter DMX ADDRESS SETTING MODE.
Press ENTER to access edit mode (the last 3 figures will blink). Use the UP and DOWN buttons to set the DMX address (A001 - A512).
Press ENTER to confirm.
14
STROBE
00 - 99 speed adjustable.
STROBE
00 - 99 speed adjustable.