Télécharger Imprimer la page

DeWalt DCMW290 Guide D'utilisation page 10

Tondeuse sans fil

Publicité

Les langues disponibles

Les langues disponibles

English
Storage Recommendations
1. The best storage place is one that is cool and dry, away
from direct sunlight and excess heat or cold.
2. For long storage, it is recommended to store a fully
charged battery pack in a cool dry place out of the
charger for optimal results.
nOTE: Battery packs should not be stored completely
depleted of charge. The battery pack will need to be
recharged before use.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
This lawn mower has been designed for professional lawn
mowing applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This lawn mower is a professional lawn care appliance.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY

DANGER: To reduce the risk of serious personal
injury, turn unit off, remove safety key, and
remove battery pack before assembly, making
any adjustments or removing/installing
attachments or accessories. An accidental start-up
can cause injury.
Adjusting Handle Height (Fig. D, E)
The mower is shipped in storage mode. You will need to
adjust the handle to operating position before continuing.
1. To unlock the handle 
 4 
from storage position, pull and
twist a half turn the two handle locks 
sides of the handle as shown in Fig. D.
2. Raise the handle to operating position.
3. Locate the two handle detent holes  
handle brackets  
as shown in Fig. E.
 7 
4. Adjust the handle to the position that best fits the
operator and lock the handle in place by untwisting the
handle locks 
 6 
allowing them to snap into the desired
detent holes.
8
Fig. D
Fig. E
Grass Collection Bag (Fig. F)

1. Ensure the mulching insert 
the mower before proceeding to step 2.
2. Lift the rear door cover 
collection bag 
hooks 
lower the rear door cover.
Fig. F
 6 
located on both
located on the
 16 
Grass Mulching Insert (Fig. G)

1. Ensure the the grass collection bag 
before proceeding to step 2.
DANGER: Remove safety key and battery pack before
removing mulching insert, and when opening rear
door cover and installing bag.
 22 
 11 
and place the grass
 12 
onto the mower so the bag
rest on the lugs 
 18 
 21 
11
18
DANGER: Remove safety key and battery pack
before removing collection bag, and when installing
mulching insert.
4
6
16
7
(Fig. G) is removed from
as shown in Fig. F. Then
21
12
 12 
is not attached

Publicité

loading