Working Procedures; Before Use; Removing/Charging/Inserting The Battery Pack; Checking The Battery Charge Level - Parkside PAMFW 12 D4 Traduction Des Instructions D'origine

Working procedures

Working principle
The oscillating drive causes the application tool to
move back and forth at a speed of 5000–20000
times per minute. This allows for precision work
even in confined spaces.
Sawing/cutting
■ Use only undamaged saw blades that are in
perfect working order. Bent, blunt or otherwise
damaged saw blades may break.
■ When sawing lightweight construction mate-
rials, follow the statutory regulations and all
recommendations from the material manufac-
turers.
■ Only soft materials such as wood, plasterboard
or similar should be processed using the plunge
saw process.
Sanding
■ To prolong the service life of the sanding
sheets , ensure that you apply even pressure.

Before use

Removing/charging/inserting
the battery pack
CAUTION!
► Always unplug the appliance before you
remove the battery pack
the battery pack to the charger.
NOTE
► The battery is supplied partially charged.
Ideally, fully charge the battery before use.
You can charge the lithium-ion battery at any
time without shortening its service life. Inter-
rupting the charging process does not
damage the battery.
PAMFW 12 D4
1. To remove the battery pack
2. Insert the battery pack
3. Insert the mains plug into the socket.
4. The green charge status indicator LED
5. Insert the battery pack

Checking the battery charge level

♦
from or connect
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
release button and pull the battery pack
out of the appliance.
charger .
The control LED lights up red.
indicates that the charging process is complete
and the battery pack
Press the ON/OFF switch
status of the battery (see also main diagram).
The status/remaining charge will be shown on
the battery display LED
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
, press the
into the high-speed
is ready.
into the appliance.
to check the
as follows:
GB │ IE │
7 ■