Water Filtration System - Kenmore 106.5004 Guide D'utilisation Et D'entretien

To Dispense Water:
1. Press a sturdy glass against the water dispenser lever. Hold
the glass close to the water dispenser spout to ensure that the
water dispenses into the glass.
2. Remove the glass to stop dispensing.
IMPORTANT: The small tray at the bottom of the dispenser is
designed to catch small spills and allow for easy cleaning. There is
no drain in the tray.
The Ice Dispenser
Ice dispenses from the ice maker storage bin in the freezer when
the dispenser lever is pressed. To turn off the ice maker, see the
"Ice Maker and Storage Bin" section.
Your ice maker can produce both crushed and cubed ice. Before
dispensing ice, select which type of ice you prefer.
Press CRUSHED for crushed ice, or CUBED
■
for cubed ice.
For crushed ice, cubes are crushed before
being dispensed. This may cause a slight delay
when dispensing crushed ice. Noise from the
ice crusher is normal, and pieces of ice may vary in size. When
changing from crushed to cubed, a few ounces of crushed ice will
be dispensed along with the first cubes.
To Dispense Ice:
1. Press the button to select the desired type of ice.
WARNING
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
2. Press a sturdy glass against the ice dispenser lever. Hold the
glass close to the ice guide to ensure that the ice dispenses into
the glass.
IMPORTANT: You do not need to apply a lot of pressure to the
lever in order to activate the ice dispenser. Pressing hard will
not make the ice dispense faster or in greater quantities.
3. Remove the glass to stop dispensing.
A
C
A. Water dispenser lever
B. Water dispenser spout
14
Cut Hazard
B
D
C. Ice dispenser lever
D. Ice guide
The Dispenser Light
On some models, the dispenser light will automatically turn on
when you use the dispenser.
If you want the light to be on continuously,
■
press LIGHT ON. To turn the light back off,
press LIGHT OFF.
The dispenser lights are LEDs that cannot be
changed. If it appears that your dispenser lights are not working,
see the "Troubleshooting" section for more information.
The Dispenser Lock
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
NOTE: The lock feature does not shut off
power to the refrigerator, to the ice maker, or
to the dispenser light. It simply deactivates the
dispenser lever. To turn off the ice maker, see
the "Ice Maker and Storage Bin" section.
To lock the dispenser, press LOCK. To unlock the dispenser,
■
press UNLOCK.

WATER FILTRATION SYSTEM

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light (on some models)
The filter status light will help you know when to change your
water filter, this is located in the refrigerator control panel.
The light will turn on red. This tells you that it is almost time to
■
change the filter.
It is recommended that you replace the filter when the status
■
light changes to red or water flow to your water dispenser or
ice maker decreases noticeably.
NOTE: The filter should be replaced at least every 6 months
depending on your water quality and usage.
Resetting the Filter Status
The reset button is located on the control panel in the
■
refrigerator compartment. To reset the status light after
changing the filter, press REFRIGERATOR TEMPERATURE within
3 seconds. The status light will change from red to off when the
system is reset.
Changing the Water Filter
Style 1
A. Water filter cover door
1. Locate the water filter cover door in the base grille, and pull
open the filter door. The filter will be released and then be
ejected as the door is opened.
A