TIPTEL 160 Manuel D'utilisation page 103

Switch from SR/HV/PR1/PR2 (see chapter Message Waiting Indication)
SR: Using burst ringing signal to switch on MWI
19. Message Waiting
HV: Using line voltage above 70V to switch on MWI
Switch
PR1: Using line polarity to switch on/off MWI
PR2: same as PR1, but polarity inverted
Note:
The Message Waiting Switch is good for operating the phone behind a PABX.
Switch position has to be PR1 or PR 2 for operation on a public line.
20. Line Jack Connect to wall socket using telephone cord supplied.
Connect e.g. data modem or answering machine, solely use devices with
21. DATA Jack
own power supply, no devices feeded from the telephone line are allowed
22. Headset Jack Western 4/4 (RJ11), use tiptel-approved headsets only
23. Handset Jack Connect handset using coil cord supplied.
24. Battery cover Use 4 x AA size batteries only (Alkaline)
Getting started
9
e
n
g