LEXIBOOK MeteoClock Mode D'emploi page 24

Multiple sensor use
1. Make sure you set each sensor to a different channel.
2. Press and hold the key for 2 or 3 seconds to synchronize manually the remote
sensors and the main unit. The weather station will detect automatically the new
sensors.
Note: it may take up to 1 minute before the main unit displays the readings.
3. Repeat steps 1 to 3 of the « Channel setting" section p.23 to select the desired channel.
4. The data of the corresponding remote sensor will be displayed in idle mode.
TEMPERATURE DISPLAY IN °C OR °F
1. In normal mode (idle screen), press the MODE/SET key three times to go the
temperature display setting.
2. Use the and keys to toggle between °C or °F temperature display (indoor and
outdoor).
3. Press the MODE/SET key to confirm your selection and go to the clock setting.
Note: After a few seconds of inactivity, the unit will go back to normal mode.
CLOCK AND DATE SETTING
Radio-clock manual synchronization
You can trigger the radio-clock synchronization manually:
1. In normal mode (idle screen), press the MODE/SET key six times to go to the RCC
function mode.
2. Press the MODE/SET key for about 2 seconds.
3. The unit displays the idle screen and the RCC icon blinks.
4. When the reception is complete, the RCC icon will stop blinking and remain solid.
Note:
• To use this function, the RCC selector must be set on the DCF or the MSF position.
• If the unit does not receive any signal, the RCC scanning will stop after 10 minutes.
Manual clock setting
If the SM2000 is brought outside the range of the DCF77 or the MSF radio signal, or
if the signal is interfered, please set the time and date manually according to the
instructions below:
24
SM2000IM0298_changed.indd 24 4/8/08 16:47:31