LEXIBOOK MeteoClock Mode D'emploi page 22

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Note:
• For an optimal reception, place the weather station away from metal objects and
electrical appliances (i.e. television, computer, monitor, etc.) to minimize interference.
• The clock automatically scans the time signal everyday between 1:00 a.m. and
5:00 p.m. hourly to maintain accurate timing.
• Most of the buttons will not function during the scan.
• If after 10 minutes the reception fails or the unit is out of auto-clock range, the scan
stops and the RCC icon
WARNING: If the unit malfunctions or receives an electrostatic shock, press the
RESET button located inside the main unit's battery compartment. If this proves to
be ineffective, remove the batteries and insert them again.
The humidifier provided with your weather station includes two function modes:
the manual mode and the automatic mode.
• In manual mode, press the "Humidifier On/Off" key to switch on or switch off the
humidifier. If the "Led On/Off" button is on the "On" position, the humidifier LED is
switched on while the humidifier is operating. When the unit is turned on, it will
operate until you press the "Humidifier On/Off" key again, or until the water tank is empty.
• In automatic mode, the humidifier starts automatically for 20 minutes if the indoor
humidity level sinks below 35%. If the "Led On/Off" button is on the "On" position,
the humidifier LED is switched on while the humidifier is operating. If you press the
"Humidifier On/Off" key when the unit is off and the automatic mode has been
selected, the humidifier will start for 20 minutes. Press the "Humidifier On/Off" key
again at any time to switch the device off.
Note: In automatic mode, once the humidifier has stopped, it will wait for 10 minutes before
checking the humidity level again and will restart if the reading is too low.
Warning:
• If the humidifier and main unit are separated, the humidifier only operates in manual mode.
• When the integrated no-water sensor detects that the water tank is empty, the humidifier
cannot be activated manually and will not start automatically. If the LED has been switched
on, it will flash until the tank has been refilled. Refill the water tank regularly.
22
SM2000IM0298_changed.indd 22
will disappear from the LCD screen.
SETTING THE HUMIDIFIER
4/8/08 16:47:29

Publicité

Table des Matières
loading

Table des Matières