Channel Selection - LEXIBOOK MeteoClock Mode D'emploi

Humidifier function mode setting (manual/automatic)
1. In normal mode (idle screen), press the MODE/SET key once to choose the
humidifier function mode.
2. Use the
("MAN" /
3. Press the MODE/SET key to confirm your selection and go to the channel setting.
Note: After a few seconds of inactivity, the unit will go back to normal mode.
The SM2000 comes with one remote sensor. The sensor's default channel is channel 1.
You do not need to change it. However, if the sensor (or the main unit) is too close to
other electrical devices, interference may cause malfunction. Use the channel selector
located inside the sensor's battery compartment to change the channel and improve
the reception. Then select the matching channel on the main unit (refer to the "Channel
setting" section below).
Channel setting
1. In normal mode, press the MODE/SET key twice to go to the channel selection
setting mode.
2. Use the
3 available channels (
empty.
as the one chosen for the remote sensor with the channel selector. If the channels are
different, the main unit will no be able to receive the data sent by the sensor.
e
3. Press the MODE/SET key to confirm your selection and go to the temperature display setting.
Note:
• After a few seconds of inactivity, the unit will go back to normal mode.
• If the sensor is exposed to very low temperatures for an extended period of time, the
s before
batteries may lose power which may cause the transmission range to be limited. High
temperatures also reduce the battery performance.
The channel function allows you to use up to 3 additional sensors. The main unit can
al mode.
identify each remote sensor thanks to their assigned channel (channel 1, 2 or 3). If you
midifier
have one or two additional sensors, you can place them in a different location in your
switched
house; in a bedroom, for example. Your main unit can collect the temperature and
humidity data of up to three remote sensors.
SM2000IM0298_changed.indd 23
and keys to select the automatic ("AUT" /
).

CHANNEL SELECTION

and keys to select the desired outdoor channel between the
, or
) or the manual mode
icons). The selected channel must be the same
23
4/8/08 16:47:30