Siemens PolyCool Superheat CPS 40 Manuel D'installation Et D'utilisation page 43

Picture Function
16 Manipulated EIV
opening degree
17 EIV actual
position
feedback to the
manipulated
opening
18 Actual value
display
Siemens
Building Technologies
Simulation mode / SIMU
(Continue with <OK> / picture 15)
Parameter Code
Setpoint * MAN EIV 0...10 V /
DC 0...10 V
signal
DC 0...10 V MAN EIV
signal EIV
0...100 %
opening
Evaporation TO
temperature
Suction gas TOH
temperature
Continously press <ESC> to exit
* Caution! At your own risk!
1) In the simulation mode, the monitoring functions are
deactivated if not enabled via D1. Therefore, your plant could
be seriously damaged.
2) In the simulation mode, the monitoring functions can be
deactivated on purpose (through D1). This allows the plant to
be manually operated for about 15 minutes.
CPS40
Adjustable Settings
range Default
0.0 V
0.1 V
- -
-
-
CE1U3372XX / H 74 319 0555 0 d
Procedure
Set parameter
/ value with +/-
Confirm with
<OK>
Back to
regulation
mode with
<ESC>
43/136
2013-10-01