Sheet Steel; Changing The Light Bulb; Side Panel Top - Wamsler W2-90 Instructions De Montage Et D'utilisation

3.7.4

Sheet steel

The steel sheet parts must be rubbed over with an acid-free sheet steel care product when
at blood temperature. Cleaning is then done when the stove is cold.
The special steel plates which radiate heat need to be taken care of regularly after each
time you cook. After any use which causes dampness or dirt to collect on the plate, you
must clean it. The hob plate should be cleaned when it is still lukewarm, which allows any
remaining water to evaporate and so prevents rust forming. Take care that you do not use
water to clean the stove when it is cold.
Expansion joints in the steel hob plate must always be cleaned free of adhesions, to avoid
deforming the steel hob plate and the side panels. If necessary the edge of the cover
should also be cleaned of any adhesions.
3.7.5

Changing the light bulb

The light bulb in the oven is exposed to high temperatures. Although it is a special kind of
bulb, it can still burn out in time. You just need to replace it with the same type of bulb
(15 W - 240 V - 300°C).
Before changing it make sure that the stove is not in use, that it is cold and that the bulb
has not been switched on. Unplug the electrical cable and check that there is no current
present. To change the bulb, remove the protective cover, change the bulb and replace the
bulb protector.
Before opening the bulb protector, disconnect the stove from the mains!
Work such as installation, setup, commissioning and servicing, as well as repairs, must
only be carried out by qualified personnel (heating system or space heating technicians).
Intervention by non-qualified persons invalidates the warranty and guarantee.
3.7.6

Side panel top

1. Stainless steel grating, lifting (Figure 5)
2. Pull forward
3. and lifting
After disassembling the stainless steel grating, can the underlying hole tray, be cleaned.
Reassembly takes place in reverse order.
Fig. 5
PLEASE NOTE:
42