DeWalt DWE7480 Guide D'utilisation page 5

WARNING: Use of this tool can generate and/or disburse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face and
body. Always operate tool in well-ventilated area and provide for proper dust removal. Use dust
collection system wherever possible.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Specifi cations
Amperes 15 A
Miter Angle 60° L and R
Bevel Angle -2° to 45° L
Blade Size 10" (254 mm)
Max. Cut Depth 0° Bevel 3-1/8" (79 mm)
Max. Cut Depth 45° Bevel 2-1/4" (57 mm)
RPM, no load 4800
Unpacking
WARNING: To reduce the risk of injury, DO NOT connect the machine to the power source
until the table saw is completely assembled and you read the entire instruction manual.
Open the box and slide the saw out, as shown in Figure 1. Carefully unpack the table saw
and all loose items from the carton. Examine all parts to make sure that parts have not been
damaged during shipping. If any parts are missing or damaged, contact your dealer to replace
them before attempting to assemble the tool.
Refer to Figure 2 for the loose items and hardware included with the saw:
1. Rip fence
2. Arbor wrench and spindle wrench (attached to saw base)
3. Blade guard assembly
4. Miter gauge
5. Push stick (attached to rip fence)
WARNING: To reduce the risk of serious personal injury, have push stick ready to
use before starting cut.
FIG. 1 FIG. 2
FEATURES (Fig. 3)
Examine Figure 3 to become familiar with the saw and its various parts. The following sections
on assembly and adjustments will refer to these terms and you must know what and where
the parts are.
FIG. 3
Q
A
P
O
M
R
U
W
V
5
C
B
D
L
E
G
H
I
N
N J
K
D
G
S
T
F