Technical Data - AEG HRB64600CB Notice D'utilisation

Problem
You can hear a constant
beep noise.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

9. TECHNICAL DATA

9.1 Rating plate
Model HRB64600CB
Typ 60 HAD 54 AO
Ser.Nr. .................
AEG
9.2 Cooking zones specification
Cooking zone
Left front
Left rear
Right front
Right rear
For optimal cooking results use
cookware no larger than the diameter of
the cooking zone.
Possible cause
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
Nominal Power (Max heat set-
ting) [W]
2300
1200
1200
1800
Remedy
Disconnect the hob from the
electrical supply. Ask a quali-
fied electrician to check the
installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 492 317 00
220 - 240 V 50 - 60 Hz
Made in Romania
6.5 kW
Cooking zone diameter [mm]
210
145
145
180
ENGLISH 13