Using The Beurer Salonpro System; Starting Treatment - Beurer IPL 10000 Mode D'emploi

8. Using the beurer SalonPro System

WARNING
If you would like to use the device on your facial area, first read the instructions in Chapter 8.2 to 8.6,
before looking at Chapter 8.1 "Starting treatment".

8.1 Starting treatment

1. Remove the base unit, applicator and other components of the beurer SalonPro System from the
box.
2. Check that the cartridge is correctly plugged into the applicator.
3. Insert the mains cable into the socket of the beurer SalonPro System BASE UNIT.
4. Insert the other end of the mains cable into a plug socket. Your beurer SalonPro System is now ready
for use.
Note
Before the treatment, ensure that the skin is shaved, clean and dry (free from any residue such as
powder, cream, make-up, antiperspirant or deodorant).
WARNING
Do not clean the skin with flammable liquids such as alcohol or acetone shortly before using the beu-
rer SalonPro System.
5. Flip the power switch on the back of the base unit. The indicator lamp and the energy indicator lamp
are illuminated and the noise of a fan (similar to the noise a hair dryer makes) can be heard.
6. The device is automatically set to the lowest energy level. The device is then ready to emit the first
pulse.
7. The energy selection buttons "-" and "+" for the energy level can be used to decrease or increase the
energy level to set the device to the level determined in the skin sensitivity test (see Chapter 7, step
2) and/or to adjust the setting to your requirements. The energy indicator lamps illuminate green in
accordance with the selected energy level.
8. Place the light area of the cartridge on the desired treatment area and make sure it is in full contact
with the skin.
Note
If you press the trigger button and your skin is to dark or too tanned, the indicator lamp on the applicator
illuminates red. In this case, the applicator does not trigger a pulse on this area of skin.
If the applicator does not have sufficient contact with the skin and you press the trigger button, the
indicator lamp on the applicator illuminates orange. In this case, the applicator does not trigger a
pulse on this area of skin either.
9. Press the trigger button. You will see a bright flash, hear a cracking noise and may feel a slight burn-
ing sensation and/or warmth. The beurer SalonPro System features a "flash-glide" function. When
you press and hold the trigger button, a bright flash is automatically triggered every three seconds,
meaning that you do not have to press the trigger button every time.
35