Table des Matières
Publicité
Mechanical installation
4.3
Assembly
4.3.1
Important notes
Brake size
28
Tab. 4:
Counter friction face design of the end shield
1)
For other materials, please consult with INTORQ.
The diameter of the shaft shoulder must not be greater than the tooth root diameter of the hub.
4.3.2
Preparation
1. Unpack the spring-applied brake.
2. Check for completeness.
3. Check the nameplate data (especially the rated voltage).
4.3.3
Overview
without separate counter friction face
INTORQ | BA 14.0196 | 04/2016
Minimum requirements: Use as counter friction surface
1)
Material
Evenness
[mm]
S235 JR
C15
< 0.1
EN-GJL-250
Axial
Roughness
run-out
[mm]
❚ Threaded holes with mini-
0.1
Rz10
❚ Free of grease and oil
with flange
Miscellaneous
mum thread depth
16
22
Publicité
Chapitres
Table des Matières
