The Remote Control System; Transmitter; Battery Charging - XciteRC Rocket 125 Mode D'emploi

The remote control system

Here you get an overview of the remote control system of your XciteRC Rocket 125 3D and its various fea-
tures and settings. Before the first flight, you should absolutely have read and understood all these functions
EN
and settings.
• Do make sure that the transmitter is turned off - POWER-LED off.
• Now open the battery compartment cover on the backside of the transmitter. Slide the cover down and
insert three size AA Alkaline batteries.
• WARNING: pay attention to the correct polarity - fire or explosion hazard!
• Close the battery compartment cover, then turn on transmitter.
• The POWER LED must lit. Attention: if the POWER LED flashes and a beep sound appears or does not
light at all, the model may not started – crash hazard! Change transmitter batteries immediately.
• WARNING: check the POWER LED also during operation. If the POWER LED starts to blink and
the sound appears, stop operation, switch the model off and replace the transmitter batteries – crash
hazard!
• ATTENTION: The maximum range of the remote control system is about 50 meters, do not fly
farther away under any circumstances - crash hazard!

Transmitter

Throttle lever
(Rise/sink,
yaw left/right)
Lights

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
USB Charger
18
Speed Flips
Video
Photo
COM P U TE R
U S B
The remote control system · Battery charging
-
+ +
- -
+
Direction lever
(forward/backward,
left/right)
Headless Mode
Power-LED
Power Switch (ON/OFF)
LiPo battery
Throttle rate
Battery level
L.H
H
%
E ASY
XciteRC Rocket 125 3D