Insert The Drive Battery; Charging The Battery; The Remote Control System; Transmitter - XciteRC 24000000 PARACOPTER RTF Mode D'emploi

Insert the drive battery

• Pull the locking lever to open the battery compart-
ment on the underside of the chassis.
EN
• Pull the plug out and connect it to the drive battery.
• Now thread the plug first, then the battery into the
chassis as shown in the figure.
• The battery compartment must be closed with an
audible "click", so it cannot suddenly open during
the flight.
2

Charging the Battery:

WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
Place the charger to a suitable, non-flammable surface. Connect the charger to a suitable power source. The
PARACOPTERs battery is equipped with an XH balancer connector. Before starting the charging process,
read the instruction manual of your charger used.

The remote control system

Here you get an overview of the remote control system of your PARACOPTER and its various features and
settings. Before the first flight, you should have read and understood all these functions and settings.
• Make sure that the transmitter is turned off - ON / OFF switch in the lower position.
• Now open the battery compartment cover on the back of the transmitter and insert four AA batteries
(or rechargeable batteries) into the battery compartment of the transmitter. Pay attention to the correct
polarity!
• Close the battery compartment cover and turn on transmitter – push ON / OFF switch upwards.
• The POWER LED must lit red.
• WARNING: If the POWER LED is flashing, supported by a beep, the model may not be started –
crash hazard! Change transmitter batteries immediately (or charge batteries).
• Pay attention to the POWER LED and the beeper also during operation. In this case, land immediately and
replace transmitter batteries (or recharge the batteries).

Transmitter

26
Battery charging
1
3
PARACOPTER