Beurer PureSkin Pro IPL 5500 Mode D'emploi page 41

growth phases. These hairs are treated in subsequent sessions and this is why several hair
removal sessions are required to achieve the best results with the device.
Is it true that some hairs grow back thinner and finer after a light-based hair removal
treatment?
This phenomenon has been excessively documented by beauticians and doctors who use
light- and laser-based hair removal devices. It is possible that some hairs grow back thinner
and finer after hair removal using the device. Normally, these hairs are a mere fraction of
those that were originally there and further treatment can have the desired effect on them.
Why can't I perform a treatment when I have an "active" tan?
Do not use the device on tanned skin or after exposure to the sun. Tanned skin, especially
after exposure to the sun, contains a large amount of the pigment melanin. This applies to
all skin types and colours, including those that do not seem to tan quickly. The presence of
a large amount of melanin exposes the skin to an increased risk of negative consequences
in relation to the use of the device, including burns, blistering and discolouration of the skin
(hyper- or hypopigmentation).
Is long-term usage of the device bad for my skin?
The use of light and laser energy in aesthetic medicine has been excessively documented
for over 15 years in professional journals that are checked by experts, and by reputable
institutions such as the Mayo Clinic. These journals and institutions have not reported
any side effects or damage as a result of long-term use of light- and laser-based devices.
After unprotected exposure to the sun, how long should I wait before performing a
treatment with the device?
You should wait two weeks after unprotected exposure to the sun before using the device.
If you are still unsure about exposure to the sun, you should consult your doctor.
Are there any particular steps I need to take before using the device?
Before each session using the device, it is important that exposure of the treated surface to
the sun is avoided for at least two weeks. This can be aided by UV sun cream (SPF 30+) and
clothing that covers the treated area. Furthermore, the area to be treated should be cleaned
with mild soap and water and the hair should be shaved down to the surface of the skin.
How should I look after the treated skin surface following a treatment?
The treated skin surface can be cleaned and cared for using commercially available skin
care products. Take particular care to avoid unprotected exposure to the sun for up to 48
hours after the treatment. Sun cream with a high sun protection factor (30+) and clothing
that covers the area provide sufficient protection from the sun.
41