Starting The Application - Beurer PureSkin Pro IPL 5500 Mode D'emploi

3. Position the light area on the skin and press the trigger button in order
to release a light pulse at level 1. Ensure that the light area and skin contact sensor
come into full contact with the skin. A light pulse can only be released once the skin
contact sensor is in full contact with the skin. You will see a bright flash, hear a cracking
noise and may feel a slight burning sensation and/or warmth. The device fan switches
on after the first flash. Within 1-3 seconds (depending on the intensity level), the de-
vice is ready for the next pulse and the indicator lamp on the device is continuously
illuminated green.
4. Position the skin contact sensor on another treatment area. Increase the intensity level
by pressing the ON/OFF/power selection button again and release a light pulse using
the trigger button. Do not exceed the maximum permitted/recommended intensity for
your skin tone (see the hair and skin colour chart on the back page of these instruc-
tions for use).
Note
Only increase the energy level if the previous level is not uncomfortable for you. If energy
level 1 is uncomfortable for you, do not increase the energy level.
5. If you experience an uncomfortable feeling after the flash, reduce the intensity.
6. Complete the skin sensitivity test. Wait 48 hours and examine the treated skin area.
If the treated skin surface appears normal (no reaction or only slight reddening), you
can treat the tested skin areas at the intensity level set for the skin sensitivity test.
Note
If your treated skin surface produces a reaction (e.g. reddening or swelling), wait until the
symptoms have fully subsided and then carry out another skin sensitivity test at a lower
intensity. If the treated skin surface reacts again, consult your doctor.

6. Starting the application

1. Insert the device plug into the device and insert the mains plug
into the mains socket. The indicator lamp begins to flash green
(stand-by).
34