Electrolux EUF1900FW Notice D'utilisation page 65

9.4 Location
100 mm
15 mm
9.5 Door reversibility
3
1
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net.To ensure best performance, if the appli-
ance is positioned below an overhanging wall
unit, the minimum distance between the top
of the cabinet and the wall unit must be at
least 100 mm . Ideally, however, the appli-
ance should not be positioned below over-
hanging wall units. Accurate levelling is en-
15 mm
sured by one or more adjustable feet at the
base of the cabinet. If the cabinet is placed in
a corner and the side with the hinges facing
the wall, the distance between the wall and
the cabinet must be at least 10 mm to allow
the door to open enough so that the shelves
can be removed.
4
2
To change the opening direction of the
door, do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that
• Unscrew both adjustable feet.
• Unscrew the screws of the door bottom
• Take off the appliance door by pulling it
WARNING!
It must be possible to disconnect the
appliance from the mains power sup-
ply; the plug must therefore be easily
accessible after installation.
To carry out the following opera-
tions, we suggest that this be
made with another person that will
keep a firm hold on the doors of
the appliance during the opera-
tions.
the compressor cannot touch the floor.
hinge.
slightly downwards.
ENGLISH 65