Installation - Electrolux EUF1900FW Notice D'utilisation

Problem
It is too cold inside
the freezer
The appliance does
not work at all. Nei-
ther cooling nor
lighting works
The appliance does
not cool at all
Green indicator
flashing
8.1 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

9. INSTALLATION
WARNING!
Read the "Safety Information" care-
fully for your safety and correct op-
eration of the appliance before in-
stalling the appliance.
Possible cause
Food placed in the appli-
ance was too warm
Products to be frozen are
placed too closely to each
other
Temperature regulator may
be set incorrectly
Plug is not connected to
the mains socket properly
Power does not reach the
appliance
The appliance is not
switched on
There is no voltage in the
mains socket (try to con-
nect another appliance into
it)
Plug is not connected to
the mains socket properly
There is no voltage in the
mains socket (try to con-
nect another appliance into
it)
The appliance is not
switched on
Temperature Regulator is
not on
Temperature sensor prob-
lem
3.
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor (garage or cellar) also,
but for optimum performance install this
Solution
Allow food to cool to room
temperature before storing.
Place the products in a way
so that cold air could circu-
late among them
Set a warmer temperature
Connect the mains plug
properly
Try connecting another elec-
trical device to the power
outlet
Switch on the appliance
Call an electrician
Connect the mains plug
properly
Call an electrician
Switch on the appliance
Check the Temperature
Regulator
Call the service personnel
If necessary, replace the defective door
gaskets. Contact the Service Center.
ENGLISH 63