GreenWorks Tools 2501907 Manuel D'utilisation page 3

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
Do not use this product if any parts on the packing list are
already assembled to your product when you unpack it.
Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
■ Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
■ If any parts are damaged or missing, please call your
Greenworks tools service centre for assistance.
PACKING LIST
■ Lawn mower
■ Battery key
■ Grassbox
■ Mulching plug
■ Operator's manual
If any parts are damaged or missing do not operate this
product until the parts are replaced. Using a product
with damaged or missing parts could result in serious
personal injury.
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
Do not insert isolator key until assembly is complete and
you are ready to mow. Failure to comply could result in
accidental starting and possible serious personal injury.
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from
the product when assembling parts.
English (Original Instructions)
WARNING
WARNING
WARNING
WARNING
WARNING
Never operate the mower without the proper safety
devices in place and working. Never operate the mower
with damaged safety devices. Operation of this product
with damaged or missing parts could result in serious
personal injury.
UNFOLDING AND ADJUSTING LOWER HANDLE
See figure 2.
■ Pull up and back on the upper handle to raise the
handle into operating position. Make certain the
handles snap into place securely.
■ Tighten the lower handle with the quick release
fasteners on both sides.
NOTE: Ensure both sides are set at the same position for
proper assembly.
INSTALLING THE UPPER HANDLE
See figure 3.
■ Align the mounting holes on the upper handle and the
lower handle. Insert the carriage bolts and use the wing
nuts to tighten them. Repeat the operation on the other
side.
INSTALLING THE GRASSBOX
See figure 4.
■ Lift the rear discharge door.
■ Lift the grass catcher by its handle and place under
the rear discharge door so that the hooks on the grass
catcher are seated on the slots.
■ Release the rear discharge door. When installed co
rrectly, the hooks on the grass catcher will extend
through the openings on the rear discharge door.
INSTALLING THE MULCHING PLUG
See figure 5.
■ Lift and hold up the rear discharge door.
■ Grasp the mulching plug by its handle and insert it at a
slight angle, as shown.
■ Push the mulching plug securely into place.
■ Lower the rear discharge door.
SETTING BLADE HEIGHT
See figure 6.
When shipped, the wheels on the mower are set to a low-
cutting position. Before using the mower for the first time,
adjust the cutting position to the height best suited for your
lawn. The average lawn should be between 38 mm and 51
mm during cool months and between 51 mm and 70 mm
2
WARNING