Publicité
Les langues disponibles
Les langues disponibles
Assembly
Assemble the filler cap.
The
hose
connection
must be as short as possi-
ble; shorten the hose con-
nection as necessary.
The top side of the
Splash-stop is equipped
with a connection for the
breather line.
This con-
nection has a turning
radius of about 200°.
Fit the Splash-stop onto the filler cap with the pre-fitted rubber
sleeve and the hose clamp included. Use water or soap, if need-
ed; do not use oil.
Secure the Splash-Stop by e.g. fastening the handles onto the
deck or gangway with strips.
Fit a filler hose between the Splash-Stop and the tank. Use fire-
proof hose with a 38 mm or 50 mm inner diameter respectively.
Place it such that no mechanical stress is placed on either the
tank or the Splash-Stop.
Place the breather nipple as high as possible above the level
of the Splash-Stop. This will prevent fuel escaping from the
breather lines.
WARNING
Choose a location for the breather nipple such that
fumes are not trapped within the ship!
Unpleasant odours can escape through the breather nipple. This
can be prevented by fitting an active carbon filter (the Vetus
Odour filter) onto the breather line. Refer to the relevant instruc-
tion manual for installation of the Vetus Odour filter.
Splash-Stop
Fit the breather hose using fireproof hose with a 16 mm inner
diameter.
The first breather hose, which is also the feed for fuel caught in
the Splash-Stop, should run from the tank to the RETURN con-
nection.
The second section of breather line should be run from the
VENT connection to the breather nipple.
The breather hose must be fitted such that there is a continuous
upward slope in relation to the tank.
Fasten all hose connections with 2 stainless steel hose clamps!
FS383851
The deck fitting and the other metal parts that may come in con-
tact with the fuel, must be grounded to prevent sparks from stat-
ic electricity. Use a wire cross-section of 1 mm
tion colour green/yellow.
Maintenance
Check the breather nipple regularly and clean the steel breather
nipple strainer whenever necessary.
Check annually:
- the anti-splash sleeve and
replace when necessary.
- the hoses and hose connections for possible leakage and
replace hoses and hose clamps when necessary.
Technical information
Reservoir volume
: 2 litres
Connections,
for filler cap
: 38 mm diameter (FS383851)
51 mm diameter (FUSTO3851)
for filler hose
: 38 mm or 51 mm diameter respectively
for ventilation
: 16 mm diameter
Material
: Polyethylene
Weight
: 1.3 kg
ENGLISH
FUSTO3851
2
minimal, insula-
5
4.0401
Publicité
