Hansgrohe Axor Massaud 18440001 Mode D'emploi page 2

8"
1⅝"
2¾" 2¾"
9½"
¼"
6⅜"
Tools Required / Outiles Utiles /
Herramientas Útiles
27 mm
3 mm
This unit meets or exceeds the following:
• ASME A112.18.1
• CSA B125.1
• Listed by IAPMO for use in the US
and Canada
2
2¾"
8⅛"
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - handshower
Flow rate - valves
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• This trim is for use with rough valve 13444181.
• The mounting surface must be finished and made
watertight before installation of this trim kit.
• Protection against backflow is provided by a
check valve in the handshower hose and by an
automatically resetting diverter.
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or other
approved anti-scald device.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
120° - 140° F*
2.5 GPM max.
approx. 6 GPM each @ 44 PSI
145 PSI
176°F*