Bosch PST 670 L Notice Originale page 23

Laser Module (PST 670 L/PST 700 PEL)
Laser type
Laser class
Operating and storage
temperature
Batteries
Declaration of Conformity
PST 700 PE: We declare under our sole respon-
sibility that the product described under "Tech-
nical Data" is in conformity with the following
standards or standardization documents:
EN 60745 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until
28 Dec 2009), 2006/42/EC (from 29 Dec 2009).
PST 670 L/PST 700 PEL: We declare under our
sole responsibility that the product described
under "Technical Data" is in conformity with the
following standards or standardization docu-
ments: EN 60745, EN 60825-1 according to the
provisions of the directives 2004/108/EC,
98/37/EC (until 28 Dec 2009), 2006/42/EC
(from 29 Dec 2009).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 25.03.2009
Bosch Power Tools
nm 650
mW
°C 0...+40
3 x 1.5 V
(LR44)
Dr. Eckerhard Strötgen
Head of Product
Certification
Assembly
Replacing/Inserting the Saw Blade
<1
Before any work on the machine itself, pull
2
the mains plug.
When mounting the saw blade, wear protec-
tive gloves. Danger of injury when touching
the saw blade.
Selecting a Saw Blade
An overview of recommended saw blades can
be found at the end of these instructions. Use
only T-shank saw blades or saw blades with 1/4"
universal shank (U-shank). The saw blade
should not be longer than required for the in-
tended cut.
Use a thin saw blade for narrow curve cuts.
Inserting the Saw Blade (see figure A1)
Clean the shank of the saw blade before in-
serting it. An unclean shank cannot be fas-
tened securely.
PST 700 PE/PST 700 PEL: If required, remove
the dust cover 11 (see "Dust Cover").
Push the saw blade holder 8 upward in the di-
rection of the arrow. Insert the saw blade 10
(teeth in cutting direction) to the stop into the
saw blade holder.
While inserting the saw blade, pay attention that
the back of the saw blade is positioned in the
groove of the guide roller 9.
PST 670 L: Precise cuts are only possible when
the guide roller 9 faces closely but not too tight
against the back of the saw blade (the saw
blade 10 may not be bent by the guide roller). If
required, loosen screw 23 and move the holder
22 of the guide roller in such a manner that the
guide roller faces closely against the back of the
saw blade. Tighten screw 23 again.
Check the tight seating of the saw blade.
A loose saw blade can fall out and lead to
injuries.
Removing the Saw Blade (see figure A2)
Push the saw blade holder 8 upward in the direc-
tion of the arrow and remove the saw blade 10.
English | 23
2 609 003 718 | (14.4.09)