VINCENT PHO-700 Manuel D'utilisation page 22

CONNECTION OF THE RECORD PLAYER (TURNTABLE)
Connect the audio cable of the record player to the RCA sockets "MC/MM IN" (11) of the PHO-700.
Establish a tight connection of the grounding cable at the clamp "GND" (8). Some record players are not
equipped with a separate grounding cable.
RCA-connection
PHO-700
CONNECTION OF THE AMPLIFIER
Connect the output sockets "OUT" (7) of the PHO-700 to a standard line level input of your integrated
amplifier or preamplifier. These inputs are in most cases named "CD", "TUNER", "AUX", "S1" or "LINE1".
Do never connect an amplifier input that is named "PHONO"!
PHO-700
RCA connection
integrated amplifier,
preamplifier or receiver
LINE IN
CONNECTION OF THE POWER SUPPLY
The purpose of the PHO-700ps is to convert the mains alternating power to a low DC voltage that is more
appropriate to supply the phono preamplifier PHO-700. So in the first place both devices must be inter-
connected using the supplied DIN cable (4)(9). Check whether the wall mains socket provides the appro-
priate mains power, which is the case if it is supplied with 230 V AC 50 Hz. After all other cable con-
nections have been made push the plug of the supplied power cable firmly into the power socket (5) on
the back of the appliance. Plug the other end of the power cable into a mains socket.
Always switch on the PHO-700 before you switch on the amplifier/preamplifier!
Vincent
22