Publicité
Les langues disponibles
Les langues disponibles
STEP 4
Place the mat (6) on the ground inside the
frame.
Make sure the back side of the mat is
facing up.
Caution: It is wise to wear leather
gloves while attaching the springs. Be
careful where you place your hands
the Springs. Be careful where you
as the springs and frame joints can
pinch.
Attach the spring(7) as follows:
1.
Hook one end of a spring into a V-ring
sewn on the jump mat.
2.
Hook a spring tool shown in the inset
drawing into the free end of the
spring.
3.
Pull it by using the spring tool until it
reaches the frame.
4.
Push the end of the spring into a hole
in the frame. Unhook the spring tool.
4.1
Attach the D-ring sewn to the corner of the
mat to the corner tube by two springs (7)
as shown. You will then have eight springs
that are attached. Two springs to each
corner.
4.2
Count exactly 10 frame holes and 10
V-rings in the 12ft direction. Attach 3
springs. Repeat on the opposite 12ft side
of the trampoline.
Count exactly 5 frame holes and 5 V-rings
in the 7ft direction. Attach 3 springs. Re-
peat on the opposite 7ft side of the tram-
poline. You should now have 16 springs
attached.
Continue to attach the remaining springs.
Note: The spring has a large hook
that attaches to the frame and a small
hook that attaches to the mat ring.
Note: As you attach springs, carefully
count the V-rings and frame holes. If
a V-ring or a hole is skipped, re-attach
the spring in the proper position.
16
4
wo springs
InTerra
Trampolines
6
7
1-A/1-B / 2-C / 2-D
5
7
2
12Ft/366cm
7(3x)
7(3x)
7
7(3x)
Publicité
