Clarion M608 Mode D'emploi Et Manuel D'installation page 21

8) Wiring and Connections
Multi-Zone mode connections
Radio Antenna
8-Channels of
Amplification
SiriusXM Connect
Tuner
(sold separately.)
Steering Wheel Remote Control Terminal
Connect
to external
wired Remote
Control Unit
(sold separately)
Left(White)
Right(Red)
Left(White)
Right(Red)
Connect to USB memory/
iPod/iPad/iPhone device
20
M608
Refer to the right
Left
ZONE 1
(White)
Right
Gray
(Red)
Left
ZONE 2
(White)
Right
Black
(Red)
Left
(White)
ZONE 3
Right
Purple
(Red)
Left
(White) ZONE 4
Right
(Red) Green
SiriusXM
Black
SWC
Black
Wired Remotes
Black
AUX IN 1
Black
AUX IN 2
Grey
USB cable
Black
Gray
Right
Gray/Black
ZONE 1
White
Left
White/Black
Purple
Right
Purple/Black
ZONE 2
Green
Left
Green/Black
4-Speaker system
or
2-Speaker system
Gray
Right
Gray/Black
ZONE 1
White
Left
White/Black
Purple
Purple/Black
Not used.
Insulate
Green
each wire
Green/Black
9) Connecting to External Amplifiers
• Connecting to External Amplifiers
External amplifiers can be connected to the 4 channel RCA output connections.
Ensure that the connectors are not grounded or shorted to prevent damage to the unit.
• If M608 is connected as a MULTI-ZONE system with Zone 3 and Zone 4 RCAs con-
nected to amplifiers, do not switch M608 to STANDARD mode.
Doing so will cause the Zone 3 amplifier to reproduce only low frequencies and the
Zone 4 amplifier to reproduce full range frequencies at maximum volume.
This may result in potential speaker and/or hearing damage.
• If M608 is connected as a TOWER configuration with Fixed/Zone4 RCAs connected
to an amplifier, do not switch M608 to STANDARD mode. Doing so will cause Fixed/
Zone4 amplifier to reproduct a full range of frequencies at maximum volume. This may
result in potential speaker and/or hearing damage.
16-Pin Connector Extension Lead
(attached to the source unit)
Yellow wire (Memory back-up lead)
Connect directly to battery
FUSE 15A
Red wire (Power lead)
Accessory 12V
Blue/White wire (Amplifier turn-on lead)
Connect to remote turn-on lead on the amplifier
Blue wire (Auto ANT lead)
Connect to Auto antenna
Black wire (Ground lead)
Connect to ground
Orange/White wire (Illumination lead)
Connect to the illumination circuit on the
boat