Publicité
Les langues disponibles
Les langues disponibles
FN-114521.1
PARTS DESCRIPTION
1.
Fan head
2.
Fastening screws
3.
Height adjustment pipe
4.
Standing shaft
5.
Height adjustment knob
6.
Standing base
7.
Weight support
8.
Fastener
9.
Base locking screw
10. Handle
11. Speed buttons
12. Control box
13. Fan head support
ASSEMBLY INSTRUCTIONS
** Please assemble correctly by the following order when using.
1. The stand assembly
Put the standing shaft into the center of standing base.
Place the weight support to the bottom of the base. Tighten the
weight support to the base with fastener and base locking
screw.
2. Fan head assembly
Pull the height adjustment pipe out to your desired height and tighten the height adjust knob.
Place the fan head onto the top of the height adjustment pipe, tighten 2 fastening screws in the fan head
support with a screw driver.
OPERATING INSTRUCTIONS:
1.
Plug the power cord into a suitable socket.
2.
The fan is switched on by using the speed buttons on the control box: 0 = OFF, 1 = Low Speed, 2 = Medium
speed, 3 = High speed.
3.
Tilting Angles: turn off and unplug the fan, then push or pull the guards to adjust the angle of airflow.
CLEANING AND MAINTENANCE
1.
Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains cable
from the socket.
2.
Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and then dry it carefully. Always take out the mains plug first.
3.
Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it occasionally
using a dry brush or vacuum cleaner.
- 4 -
EN
Publicité
