Set-Up; Operating Instructions - QEP 21665Q Manuel D'utilisation

SET-UP

1. POWER SOURCE
Ensure that the power source to be utilized conforms to the power requirements
specified on the product nameplate.
2. POWER SWITCH
Ensure that the power switch is in the OFF position. If the plug is connected to a
power receptacle while the power switch is in the On position, the power tool will start
operating immediately, inviting serious injury.
3. EXTENSION CORD
When the work area is removed from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as short
as practical.
4. MIXING PADDLE
Secure the male-threaded paddle in the chuck and tighten with supplied wrench.

OPERATING INSTRUCTIONS

MIXING
For mixing thin-set, grout, mortar and paint.
CAUTION: Use extreme caution to avoid getting water in the mixer, and around your
working area. Add water to the mix container away from the mixer, electrical supply
cords, and your work area. Wear rubber boots and gloves when mixing material
containing water.
In the event water enters the power mixer housing, DO NOT OPERATE THE MIXER
UNTIL IT IS COMPLETELY DRY! Damage to your mixer, electric shock, or severe bodily
injury may occur!
a. To keep the mixer motor running at full speed without continuously squeezing
the trigger:
1. First, squeeze the trigger.
2. Then, press the trigger lock button.
3. While pressing the button, release the trigger.
The mixer is now locked into the ON position and will continue to run.
To release the trigger lock, squeeze the trigger.
b. Secure the provided male-threaded mixing paddle in the chuck with the
supplied wrench. The supplied mixing paddle is ideal for thinset grouts and
other viscous materials.
c. If using a non-threaded mixing paddle, you must use
the included Chuck Kit. Simply attach the chuck to the
M-14 chuck screw and then attach the other end of the
M-14 screw to the mixer (as shown), using the
wrench provided. Now use the chuck key to tighten the
chuck around the shaft of the mixing paddle.
d. Use a bucket or mixing vessel at least 25% larger than
the volume of material you intend to mix. Do not fill
the container to the top. For example, if you are using a five gallon bucket,
leave at least four inches at the top to minimize spills and splashing.
- 6 -
C.