Operating Your Veinwalker - GlobalMIND VeinWalker pro Mode D'emploi

Operating your VeinWalker

pro
©
Connect the tubes to the valves on the leg cuffs and plug the other end of the
tubes into the control device. Before use, make sure that the tubes are securely
attached to the valves and connected correctly to the control device. Now put on
the leg cuffs of your VenenWalker . Make sure that the tubes do not get bent dur-
®
ing use. Only use one cuff. Plug the second opening of the control unit with the
I
stopper. Now turn on your VeinWalker pro by pressing the switch .
©
Your legs are massaged by an airbag that goes up and down.
(Please do not open the zips during the massage since they could be damaged!)
The massaging of your legs has the same effect on your veins and muscles as light
exercise. You can lie down and position your VeinWalker pro next to you.
©
The picture shows how to make optimal use of your VeinWalker pro.
©
Picture
1
In order to allow the blood to circulate unhindered, the leg around which the cuff
is placed must be stretched out during application!
31