Kuppersbusch IKE3180-1 Notice D'utilisation page 25

ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Door reversibility
The door of the appliance opens to the
right. If you want to open the door to the
left, follow these steps before you install the
appliance:
1. Loosen and remove the upper pin.
2. Remove the door.
3. Remove the spacer.
4. With a key, loosen the lower pin.
On the opposite side:
1. Tighten the lower pin.
2. Install the spacer.
3. Install the door.
4. Tighten the upper pin.
Ventilation requirements
The airflow behind the appliance must be
sufficient.
min.
200 cm
Installing the appliance
Caution! Make sure that the mains
cable can move freely.
Do the following steps:
1. If necessary cut the adhesive sealing
strip and then apply it to the appliance
as shown in figure.
2
min.
200 cm
2
25