VESTEL PDM-49UG02 Manuel D'utilisation page 32

GETWB
SET3DMODE
SETVIRTUAL3D
CONTRASTUP
CONTRASTDOWN
GETENERGYSAVING
GETPOWERSAVE
GETCOLOURTEMP
GETHUE
GETSKINTONE
GETPATTERN
Command
SETROWCOUNT
GETROWCOUNT
SETCOLUMNCOUNT
GETCOLUMNCOUNT
SETCELL
GETCELL
SETOFFSET
GETOFFSET
SETVIDEOWALL
GETVIDEOWALL
Get white balance value.
Set 3D mode values
(values are off, auto, side
by side, top bottom and
game)
Set virtual 3d values.
Inrease Contrast Level
by 1 step
Decrease Contrast Level
by 1 step
Get energy saving mode.
(if enabled from profile)
Get power save mode
Get colour temperature.
Get picture hue value.
Get picture skin tone
value.
Get selected pattern of
the Monitor screen
VIDEO WALL COMMANDS
Description
Set row count.
Get row count.
Set column count.
Get column count.
Set cell.
Get cell.
Set offset.
Get offset.
Set videowall parameters
Get videowall parameters no parameter
English - 31 -
str-int type (type = redgain,
greengain, bluegain,
redoffset, greenoffset,
blueoffset)
int n (n = off, auto, side by
side, top bottom, game)
int n (0 = off, 1 = low, 2 =
medium, 3 = high)
no parameter
no parameter
no parameter
no parameter
no parameter
no parameter
no parameter
no parameter
Parameter
integer n (0 ≤ n ≤ 100)
no parameter
integer n (0 ≤ n ≤ 100)
no parameter
integer n (0 ≤ n ≤ 100)
no parameter
integer n (0 ≤ n ≤ 100). n is
the number of pixels which
will be cropped from all four
sides.
no parameter
"parameters for items in
following format:
RowCount-ColumnCount-
Cell-Offset"
#* type ...
"#*set3DMode() set to n
#*Incorrect 3d mode parameter
entered"
"seMonitorirtual3D() set to n
Incorrect virtual 3d mode
paramater entered
"
Picture contrast value is set to ...
Picture contrast value is set to ...
#*The energy saving mode is ...
"#*Powersavemode is ON
#*Powersavemode is OFF"
#*Colour temp is ...
#*Hue level is ...
#*Picture skin tone is ...
The pattern is ...
Return
#*set row count to n
#*row count is ...
#*set column count to n
#*column count is ...
#*set cell to n
#*cell is ...
#*set offset to n
#*offset is ...
#*set row count to ..., set column
count to ..., set cell to ..., set offset
to ...
#*row count is ..., column count is
..., cell is ..., offset is ...