VESTEL PDM-49UG02 Manuel D'utilisation page 16

Link options
Pixel shift
USB Information
Power on Delay
USB operations
No Signal
No signal Power off
Auto launch
Last Status
Panel Lock
RCU Inhibit
Volume Settings
USB Option
Boot Up Picture mode
UART 0
Press OK to open the Link Options menu screen. Current Start url and Settings url
links will be displayed. These items are for information only and not selectable. Open
browser initial page and NTP server link preferences can be configured using the
related options.
Enables or disables pixel shifting. This option can be used to avoid image retention (after
image effects) that can occur when displaying fixed patterns or still images for a long
periods of time. If enabled, the picture and OSD (On-Screen Display) will be shifted at
specified time intervals.
Press OK to open the USB information menu screen. Current Total space and Free
space informations of the connected USB device will be displayed. You can also format
the connected USB device using the Format Disk option in this menu (FAT32 format
only).
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
Highlight and press OK to perform USB operations.
Sets the behavior preference of the Display, when no signal is detected from the currently
set input source. Failover and Input Search options are available.
If Failover is selected the Display checks the connected USB device for available files to
play. If no playable files are available or there is no USB device connected to the Display,
the No Signal image will be displayed. If there isn't any No Signal Image available, No
Signal OSD will be displayed on the screen. The setting of the Auto Play option in the
Media Browser>Settings menu is not important, in Failover mode it will function anyway.
If Input Search is selected the Display will search all available input sources consecutively
to find signal. If no signal is detected from other available sources, No Signal OSD will
be displayed and the Display will turn itself off after a period of 30 seconds.
When enabled the Display will turn itself off after a period of 5 minutes, if no signal is
received from the selected source.
This feature will only work if all of the following circumstances occur:
- No Signal option is set as Failover.
- USB device is not connected to the Display / USB device is connected but there are
no playable files installed in the USB device.
Configures the auto launch preference. CMS(Start url), Open Browser(Open Browser
initial page) and Disabled options are available.
Set as On to enable the Display to reopen with the closing status.
Set as Off to prohibit the use of the buttons on the Display.
Set as On to inhibit the use of the remote. Remote control will function in Stand-By
mode independently from the setting of this option. If this option is set as Limited only
the Volume Up/Down, Numeric Buttons and the Standby button on the remote will be
functional.
Press OK to see available menu options.
Set as Off to disable the USB ports on the Display. You can also set this option as 5V
to provide 5 volts power over USB. In this case it will still not be available to browse the
USB content via Media Browser feature of the Display.
Configures the picture mode preference at power on. If set as Off the last set picture
mode will be used at power on.
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is not working while debug logs are enabled. If it is
wrongly changed to HEX while debug logs are enabled, revert the selection to ASCII and
reboot the Display in order to correct the debug logs and the ASCII protocol behaviour.
Also note that HEX protocol will work with the baud rate value 19200 for UART0
English - 15 -