Troubleshooting - Tanita BC-541N Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17

TROUBLESHOOTING

If the following problems occur ...then...
• A wrong weight format appears followed by kg, lb, or st-lb
Refer to "Changing the Weight Mode" on p.3.
• "Lo" appears on the display, or all the data appears and immediately disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the
accuracy of your measurements. Change all the batteries at the same time with new AA-size batteries.
Note: Your settings will not be erased from the memory when you remove the batteries.
• "Err" appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit.
• The Body Fat Percentage reading does not appear or "-----" appears after the weight is measured.
Your personal data has not been programmed. Follow the steps on p.4.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the
measuring platform.
• "OL" appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
Specifications
BC-541N
Weight Capacity
150 kg (330 lb) (23st 8 lb)
Weight Increments
0.1 kg (0.2 lb) (0.2 lb)
Body Fat Increments
0.1%
Personal Data
5 memories
Power Supply
4 AA batteries (included)
Power Consumption
60 mA maximum
Measuring Current
50 kHz, 6.25 kHz, 100 µA
Notice:
These marks can be found out on contaminant-containing
Batteries: Pb Pb = Battery contains lead,
Cd Cd = Battery contains cadmium,
Hg Hg = Battery contains mercury.
Not allowed to mix batteries with consumer wastes!
As consumer you are legally bound to return used or discharged
batteries. You can deposit your old batteries at the public collecting
points in your town, or wherever the corresponding batteries are sold
and specifically marked collecting boxes have been set up. In case of
scrapping the apparatus, the batteries should be removed from it and
deposited at the collecting points as well.
The device features radio interference suppression in
compliance with EC regulation 2004/108/EC
7

Publicité

Table des Matières
loading

Table des Matières