Burner Description; Burner Equipment; Accessories - Riello Gulliver RG5D Manuel D'entretien

1.

BURNER DESCRIPTION

Two stage gas oil burner.
Burner with CE marking in conformity with EEC Directives: EMC 89/336/EEC - 2004/108/EC, Low Voltage
73/23/EEC - 2006/95/EC, Machines 98/37/EEC and Efficiency 92/42/EEC.
CE Certification No.: 0036 0325/01 as 92/42/EEC.
The burner meets protection level of IP X0D (IP 40), EN 60529.
The burner is approved for intermittent operation as per standard EN 267.
Fig. 1
1 – Pump
2 – Valve casing assembly
3 – Control-box
4 – Reset button with lock-out lamp
5 – Flange with insulating gasket
6 – 2 nd stage air damper adjustment assembly
1.1

BURNER EQUIPMENT

Flange with insulating gasket . . . . No. 1
Screw and nuts for flange . . . . . . No. 1
4 pin plug . . . . . . . . . . . . . . . . . . No. 1
1.2

ACCESSORIES

DIAGNOSTIC SOFTWARE KIT
A special kit is available that detects the life of the burner through optical connections with a PC showing
the duty hours, number and types of lockout, control box serial number etc...
Do the following to display the diagnostic:
Connect the kit supplied separately to the appropriate socket on the control box.
The information is read after the software program in the kit is booted.
REMOTE RESET KIT
The burner is fitted with a remote reset kit (RS) consisting of a connection to which a button can be con-
nected up to a distance of 20 meters.
For the installation, remove the protection block installed in the factory and install the block that is supplied
with the burner (see wiring diagram on page 6).
3367
3
5
D7822
7
7 – Nozzles holder assembly
8 – Photoresistance
9 – Hydraulic jack
10 – 4 pole socket
11 – 2 nd stage valve
12 – 1 st stage valve
Screw and nuts for flange to be fixed to boiler . . . .No. 4
Flexible oil pipes with nipples. . . . . . . . . . . . . . . . .No. 2
Remote reset connection . . . . . . . . . . . . . . . . . . .No. 1
2 GB
8 11
4
1 12
6
9
10
2