Novy 828 Mode D'emploi Et D'installation page 13

Maintenance
Access to the filter
The hood is equipped with on or two metal grease
filters, which, according to the frequency of use,
have to be cleaned at least every month.
Access to the grease filter
You can remove the filter by pulling the handle in
the filter (2).
Protect the cooking plate. You can take the grease
filter out of the hood by pulling the handle that
has been placed on the filter. The filter will come
down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a
liquid detergent. Rince and allow to dry com-
pletely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Replacing the lamps
First take the plug from the wall socket or switch
off the power group. Let the lamps cool down
sufficiently before replacing them.
A suction cup for removing the lamps has been
delivered with the hood. Place the suction cup
onto the halogen spot and draw it towards you.
The lamp will now come out. You can also install
the new lamp using the suction cup.
Electrical connection
Electrical output: electrical cord + plug with
ground. To be plugged into socket with ground.
Check for compatibility with information on type
plate (behind filter).
Socket must be within reach.
Changes or replacement of the electrical cord
should be performed by a professional only.
Dimensions: p. 14
Electrical scheme: p. 15
EN 13