Publicité
Les langues disponibles
Les langues disponibles
2.
Bevel angle
(1)
0° bevel angle
1
3
2
Lower the handle fully and lock it in the low-
ered position by pushing in the stopper pin.
Loosen the lever at the rear of the tool.
Turn the 0° bevel angle adjusting bolt on the
left side of the turn base two or three revolu-
tions counterclockwise to tilt the blade to the
right.
Carefully square the side of the blade with the
top surface of the turn base using the triangu-
lar rule, try-square, etc. by turning the 0°
bevel angle adjusting bolt clockwise. Then
tighten the lever securely.
1
Make sure that the pointer on the turn base
point to 0° on the bevel scale on the arm. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
4
001850
1. Lever
2. Turn base
3. 0° bevel angle
adjusting bolt
001819
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn base
3
001851
1. Pointer
2. Bevel scale
1
3. Turn Base
2
4. Arm
3
(2)
45° bevel angle
Adjust the 45° bevel angle only after perform-
ing 0° bevel angle adjustment. To adjust left
45° bevel angle, loosen the lever and tilt the
blade to the left fully. Make sure that the
pointer on the turn base points to 45° on the
bevel scale on the arm. If the pointer does not
point to 45°, turn the 45° bevel angle adjust-
ing bolt on the right side of the arm until the
pointer points to 45°.
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10 min-
utes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If elec-
tric brake is not working well, ask your local Makita ser-
vice center for repair.
16
001852
1. Bevel scale
1
2. Pointer
2
3. Lever
3
4. 45° bevel angle
adjusting bolt
4
001145
1. Limit mark
1
001853
1. Screwdriver
2. Brush holder
cap
1
2
Publicité
