DeWalt DW088 Guide D'utilisation page 3

If you have any questions or comments about this or any D
(1-800-433-9258).
Safety Instructions for Lasers
WARNING! Read and understand all instructions. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.

WARNING! Laser Radiation Exposure. Do not disassemble or modify the laser level. There are no user serviceable
parts inside. Serious eye injury could result.

WARNING: Hazardous Radiation. Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
• Do not operate the laser in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power
tools create sparks which may ignite the dust or fumes.
Use the laser only with the specifically designated batteries. Use of any other batteries may create a risk of fire.
•
• Store idle laser out of reach of children and other untrained persons. Lasers are dangerous in the hands of untrained users.
• Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one
laser, may create a risk of injury when used on another laser.
• Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified
personnel may result in injury. To locate your nearest D
www.D WALT.com on the Internet.
e
Do not use optical tools such as a telescope or transit to view the laser beam. Serious eye injury could result.
•
• Do not place the laser in a position which may cause anyone to intentionally or unintentionally stare into the laser
beam. Serious eye injury could result.
• Turn the laser off when it is not in use. Leaving the laser on increases the risk of staring into the laser beam.
• Do not disassemble the laser tool. There are no user serviceable parts inside.
• Do not modify the laser in any way. Modifying the tool may result in Hazardous Laser Radiation Exposure.
• Do not operate the laser around children or allow children to operate the laser. Serious eye injury may result.
• Do not remove or deface warning labels. Removing labels increases the risk of exposure to radiation.
• Position the laser securely on a level surface. Damage to the laser or serious injury could result if the laser falls.

WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals
known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work
in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities.
Wear protective clothing and wash exposed areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on
the skin may promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/or disburse dust, which may cause serious and permanent respiratory or other
injury. Always use NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct particles away from
face and body.
• The label on your tool may include the following symbols.
V .................................volts
mW ............................milliwatts
...........laser warning symbol
WALT tool, call us toll free at: 1-800-4-D
e
SAVE THESE INSTRUCTIONS
WALT service center call 1–800–4-D
e
nm ..............................wavelength in nanometers
II (2) ...........................Class II (2) Laser
1
WALT
e
WALT (1–800–433–9258) or go to http://
e
ENGLISH