Makita BTD044 Mode D'emploi page 7

5. The lamp on the right side of the display starts to blink
so that the number of second digit can be changed.
6. Press the button and choose the desired number.
The displayed number changes fast by keeping
pressing the button. To set the second digit, pull
the switch trigger and then release it.
7. For the final setting, pull the switch trigger while
pressing the indication button. The number of
impacts is set at once.
To reconfigure the number of impacts, pull the
trigger without pressing the indication button so
that return to 3 above.
Confirming the current setting number
To check the current setting number, pull the trigger
once, release it and then press the indication button.
Relation between presetting number and
action
Presetting
Clockwise rotation
number
0 Auto-stop setting does not work.
01 - 99 After impacting [number of
impacts (presetting number
x 2) x 0.02] seconds.
Green color lamp lights on.
Switch off before impacting
[number of impacts
(presetting number x 2)
x 0.02] seconds.
Red color lamp lights on.
Then, the lamp goes out.
003611
NOTE:
Use presetting number as a guideline. To keep the
•
fastening torque, number of impacts changes
automatically by remaining battery capacity.
Indicating lamp
013665
After impacting preset numbers, the indicating
•
lamp lights in green color.
The red color light will light on if the trigger is released
•
before the presetting number of impacts is achieved.
It indicates that the operation is incomplete.
When auto-stop mechanism is working, the
•
indicating lamp lights red while the switch trigger is
being pulled.
Counterclockwise rotation
Auto-stop setting does not work.
Auto-stop setting does not work.
Indication lamp goes out.
1. Indicating lamp
1
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing driver bit or socket bit
12 mm
(15/32")
001266
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
2
1
013580
To install the bit, pull the sleeve in the direction of the
arrow and insert the bit into the sleeve as far as it will go.
Then release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the
•
sleeve, the sleeve will not return to its original
position and the bit will not be secured. In this
case, try re-inserting the bit according to the
instructions above.
OPERATION
[*1] Presetting number of impacts is impossible for more
than 200 impacts (4 seconds).
[*2] Fastening time includes when you pull the trigger
completely.
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque, fastening time and number of impacts
(presetting number) is shown in the figures.
7
9 mm
(3/8")
1. Sleeve
2. Bit